Ruffstuff Ford Rear Dana 60 Disc Brake Brackets, '76 & older

Description

Requires single steel wheel 15" with a maximum 4" back spacing
Here you are, an easy bolt on bracket for the Pre '77 Ford full float D60 axles! This one also uses the GM Caliper ('73-87 3/4 Ton 4x4 Front) because it is 1/2 the cost of the Ford and way less expensive to put together than the wedge system. The rotor is a 73-87 Chevy 3/4 4x4 Ton Front rotor. These were a long time coming but way worth the wait! These are only for the Ford D60, if someone tells you they are the same hang up the phone, these are for the early Ford D60, the ones with slip on drums. Remember that distinction because there are 3: Ford, GM &  Dodge are all different! All of our brake brackets are sold in pairs.
*NOTE* Double check your wheel stud diameter and length.
Dormin #610-180 usually works. Studs should drop freely into the rotor. DO NOT press studs into the rotor. If your hub has too large of studs you will need to drill the rotors to accept them. Be sure to have minimum 5/8" lug nut thread engagement
NAPA Part numbers for '73-'87 3/4 Ton Front, 4x4, Chevy Calipers and Rotors:
Caliper ONLY: LH - N4674, RH - N4673 - Both of these are LATER year part numbers
OR
LH - N4597, RH - N4596 - Both of these are EARLIER year part numbers
Rotor Only - 4885677 - all years
Brake line-
H86572